2015 Touring – TURN SIGNAL LAMPS – REAR TURN SIGNAL LAMPS BRACKET

Removal: All but FLHX/S, FLTRX/S

1. Remove circuit board and chrome base. See 7.11 REAR LIGHTING.

2. Remove rear turn signal lamps from bracket. See 7.14 TURN SIGNAL LAMPS, Rear Turn Signal Lamp.

3. If equipped with license plate lamp on turn signal bracket, remove terminals from license plate lamp connector. See A.21 TYCO 070 MULTILOCK UNSEALED CONNECTOR.

4. Remove two screws to free rear turn signal lamps bracket from rear fender.

5. Remove two screws to free license plate bracket and lamp, if equipped.

Installation: All but FLHX/S, FLTRX/S

1. Install license plate bracket and lamp, if equipped, onto turn signal bracket. Tighten to 60-90 in-lbs (6.8-10.2 Nm).

2. Apply one drop of LOCTITE 271 HIGH STRENGTH THREADLOCKER (red) to screws.

3. Install rear turn signal lamps bracket. Tighten to 84-144 in-lbs (9.5-16.3 Nm).

4. If equipped with license plate lamp on turn signal bracket, route wires through hole in fender and install terminals into license plate lamp connector. See A.21 TYCO 070 MULTILOCK UNSEALED CONNECTOR. Also refer to Table 7-16.

5. Install rear turn signal lamps in bracket. See 7.14 TURN SIGNAL LAMPS, Rear Turn Signal Lamp.

6. Install chrome base and circuit board assembly. See 7.11 REAR LIGHTING.

Removal:FLHX/S, FLTRX/S

1. Models with tail lamp:
a. Remove circuit board and chrome base. See 7.11 REAR LIGHTING.
b. See Figure 7-45. Release turn signal lamp harnesses (4) from cable clips.
c. Remove terminals from license plate lamp connector. See A.21 TYCO 070 MULTILOCK UNSEALED CONNECTOR.

2. Models without tail lamp:
a. See Figure 7-46. Disconnect turn signal connector (3) from rear fascia lamp.
b. Release harness from J-clamp (2) located above fascia lamp.
c. Push grommet (1) rearward out of hole in fender.

3. Remove two screws to release rear turn signal lamps bracket. Remove bracket and harnesses

4. Remove screws to release license plate bracket and lamp from turn signal bracket.

Installation: FLHX/S, FLTRX/S

1. Install license plate lamp and bracket onto turn signal bracket. Tighten to 60-90 in-lbs (6.8-10.2 Nm).

2. Models with tail lamp: Feed socket housings of left and right rear turn signal lamps and license plate wire terminals through respective holes to inboard side of fender.

3. Models without tail lamp:
a. See Figure 7-47. Install grommet (1) and orient as shown.
b. Route harness through hole in fender and seat grommet in hole.

4. Apply one drop of LOCTITE 271 HIGH STRENGTH THREADLOCKER (red) to screws.

5. Install rear turn signal lamps bracket. Tighten to 84-144 in-lbs (9.5-16.3 Nm).

6. Models with tail lamp:
a. Install terminals into license plate lamp connector.
See A.21 TYCO 070 MULTILOCK UNSEALED CONNECTOR. Also refer to Table 7-16.
b. Install chrome base and circuit board assembly. See 7.11 REAR LIGHTING.

7. Models without tail lamp:
a. See Figure 7-46. Install connector (3).
b. Secure harness in J-clamp (2) and under tab on end of fascia lamp.