Removal
NOTE
The Tour-Pak may be equipped with either side marker lamps or trim strips depending on model. Removal and installation are similar.
1. Remove Tour-Pak liner. See 2.34 TOUR-PAK SERVICE, Tour-Pak Liner.
2. Remove Tour-Pak. See 2.33 TOUR-PAK.
NOTE
See Figure 7-33. Screws (3) secure both the ground plate and marker lamp/trim strip.
3. See Figure 7-33. Remove four screws (3) securing ground plate. Disconnect two ground connectors. Remove ground plate.
4. Lamp equipped:
a. Disconnect side marker lamp connector (4 or 6).
b. Remove split bushing. Pull harness and connector through hole.
Installation
1. Lamp equipped:
a. See Figure 7-33. Feed connector through hole in Tour-Pak and place side marker lamp into position.
b. Install split bushing.
c. Connect side marker lamp connector (4 or 6).
2. Install ground plate with four screws (3). While holding lamps or trim strips in position, tighten to 20-25 in-lbs (2.3-2.8 Nm).
3. Mate two ground connectors to ground plate.
4. Install Tour-Pak. See 2.33 TOUR-PAK.
5. Install Tour-Pak liner. See 2.34 TOUR-PAK SERVICE, Tour-Pak Liner.
Leave a Reply