2015 Touring – TOUR-PAK LIGHTS – TOUR-PAK LIGHTS HARNESS

Written by

Removal

1. Remove Tour-Pak liner. See 2.34 TOUR-PAK SERVICE, Tour-Pak Liner.

2. Remove Tour-Pak. See 2.33 TOUR-PAK.

3. See Figure 7-33. Remove radio antenna cable (7).

4. Remove nut and ring terminal securing CB antenna cable (8).

5. Remove four screws (3) securing ground plate. Disconnect two ground connectors. Remove ground plate.

6. Disconnect side marker lamp connectors (4, 6).

7. Disconnect power outlet connector (2).

8. Push grommet with harness out toward front. Remove Tour-Pak lights harness.

Installation

1. See Figure 7-33. Install rubber grommet on harness with the split down. Position next to cable strap (1).

2. Route Tour-Pak lights harness through hole into Tour-Pak.
Install grommet.

3. Place harness at bottom of Tour-Pak.

4. Mate marker lamp (4, 6) and power outlet (1) connectors.

5. Install ground plate with four screws (3). Tighten to 20-25 in-lbs (2.3-2.8 Nm).

6. Connect audio radio antenna cable (7).

7. Install CB antenna cable (8), flat washer and nut onto stud.
Tighten to 14-16 in-lbs (1.6-1.8 Nm).

8. Install Tour-Pak. See 2.33 TOUR-PAK.

9. Install Tour-Pak liner. See 2.34 TOUR-PAK SERVICE, Tour-Pak Liner.

Comments