Removal
1. Remove outer fairing and front fender. See 2.48 FRONT FENDER.
2. See Figure 7-29. Remove nuts (2) securing left fender trim strip. Remove trim strip.
3. Remove nuts (3) securing fender tip lamp. Remove lamp and harness assembly.
Installation
NOTE
Over-tightening screws can crack the bracket or scratch the fender paint.
1. See Figure 7-29. Mount fender tip lamp. Secure with nuts (3). Tighten to 20-25 in-lbs (2.3-2.8 Nm).
2. See Figure 7-30. Route harness through trim strip and into oblong hole (5). Confirm harness routes between trim strip and tee bolt.
3. Secure trim strip with two nuts. Tighten to 10-15 in-lbs (1.1-1.7 Nm).
4. See Figure 7-29. Route harness between fender and fender mounting bracket (1).
5. Route harness out through grommet and install connector housing.
6. Install fender and outer fairing. See 2.48 FRONT FENDER.
Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
7. Test lamp for proper operation.
Leave a Reply