Removal
1. Remove left saddlebag and left side cover.
2. See Figure 7-26. Cut cable strap (3).
3. Separate connector (2).
4. See Figure 7-27. Release harness from upper clips (1).
5. Release harness from molded clips (2) on fascia.
6. Disconnect harness from fender tip lamp.
7. Note harness routing. Remove harness.
NOTE
Canadian models have both a turn signal light bar and tail lamp, and include an extra jumper harness.
8. Canadian Models: See Figure 7-28.
a. Remove rear fender. See 2.49 REAR FENDER.
b. Remove tail lamp lens.
c. Disconnect jumper harness (2) from the rear fascia lamp and the tail lamp.
d. Release jumper harness from clamps (1, 3) and remove from fender.
Installation
1. Canadian Models: See Figure 7-28.
a. Route jumper harness (2) from tail lamp to the fascia lamp and connect to each lamp.
NOTE
Do not over-tighten screws.
b. Install tail lamp lens and tighten screws to 20-24 in-lbs (2.3-2.7 Nm).
c. Secure jumper harness with clamps (1, 3). Install fender. See 2.49 REAR FENDER.
2. See Figure 7-26 and Figure 7-27. Route harness in approximate position, passing back under frame cross member and through opening in left caddy.
3. See Figure 7-27. Pass harness over antenna mount (3). Secure harness in molded clips (2) on inside of fascia.
Connect to fender tip lamp. Pull harness up to remove slack near fender tip lamp.
4. Secure harness in three upper clips (1).
5. See Figure 7-26. Pull slack from harness. Secure rear lighting harness and antenna cable to left upper frame with new cable strap (3).
6. Mate connector (2). Secure connector housing to upper caddy.
7. Install side cover and saddlebag.
Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can result in death or serious injury. (00316a)
8. Check operation of all lamps.
Leave a Reply