After Top End Service
1. Secure top engine stabilizer bracket to front cylinder head. Tighten to 30-35 ft-lbs (40.7-47.5 Nm).
NOTE
Check each end of the stabilizer link for excessive wear before installation. The spherical ball end may rotate freely, but should not have any lateral movement. Replace the link if lateral movement exists.
2. Secure engine stabilizer link to frame weldment. Tighten to 30-35 ft-lbs (40.7-47.5 Nm).
3. Secure horn bracket to front cylinder head.
4. Release disconnected branches of main harness from top of wire trough.
5. Install induction module. See 4.13 INDUCTION MODULE.
6. Continue with steps under After Cam Compartment Service.
After Cam Compartment Service
1. Twin-Cooled models: See C.5 COOLING SYSTEM REPAIR, Upper Coolant Line Installation.
a. Connect coolant manifolds to cylinder head lines.
b. Install clamp securing hoses to front rocker cover.
2. Install purge solenoid hose, if equipped, to induction module. See 4.20 EVAPORATIVE EMISSIONS CONTROL
SYSTEM.
3. Install spark plugs and connect spark plug cables.
4. Install air cleaner assembly. See 4.5 AIR CLEANER ASSEMBLY.
5. Install fuel tank. See 4.6 FUEL TANK.
6. Install exhaust system. See 4.18 EXHAUST SYSTEM.
Leave a Reply