Main Cable
NOTES
• Replacement of the radio and CB antenna cables is basically the same.
• Most of the original cable will remain within the main harness conduit.
1. Remove seat and fuel tank. See 4.6 FUEL TANK.
2. Remove outer fairing. See 2.37 OUTER FAIRING AND WINDSHIELD: FORK MOUNTED FAIRING MODELS.
3. See Figure 7-101. Disconnect antenna cable from radio.
Cut cable where it exits front and rear of the main harness.
4. Remove wire trough cover.
5. See Figure 7-102. Disconnect antenna cable connector at rear fender
6. Cut cable strap (3). Remove antenna cable.
Cable Extension: Models with Tour-Pak
1. Remove Tour-Pak harness. See 7.13 TOUR-PAK LIGHTS, Tour-Pak Lights Harness.
2. See Figure 7-104. Cut cable strap (2). Peel away the forward wrap (3).
3. CB antenna cable (6):
a. Remove tape (5) securing cable to harness.
b. Remove antenna cable.
4. Radio antenna cable (7):
a. Cut antenna cable extension where it exits each end of harness wrap.
b. Remove antenna cable.
Cable Extension: FLHX/S, FLTRX/S
1. Remove left saddlebag.
2. See Figure 7-103. Release antenna cable from three upper clips (1).
3. Disconnect antenna cable from antenna.
4. See Figure 7-105. Disconnect antenna cable connector (1). Remove cable.
Leave a Reply