Main Cable
1. See Figure 7-101. Connect new radio antenna cable connector to radio.
2. Route free end of radio antenna cable rearward along left side of steering head and rearward through left side of wire trough. Continue along inboard side of left upper frame tube and rearward to top of rear fender.
3. See Figure 7-102. Mate antenna cable connectors at top of rear fender. Install cable strap (3).
4. Capture antenna cable and main harness in steering head retainer.
5. Install two new cable straps to secure antenna cable and main harness to left upper frame tube.
6. Install wire trough cover. Verify that all latches are fully engaged.
7. Install fuel tank and seat. See 4.6 FUEL TANK.
8. Install outer fairing. See 2.37 OUTER FAIRING AND WINDSHIELD: FORK MOUNTED FAIRING MODELS.
Cable Extension: Models with Tour-Pak
1. See Figure 7-104. Lay new antenna cable along harness with front connector approximately even with the other antenna cable connector (8).
2. Secure cable to harness with tape (5).
3. Install new forward wrap (3) next to rear wrap (4) remaining on harness.
4. Install new cable strap (2) 2 in (51 mm) (1) from end of forward wrap.
5. Install Tour-Pak harness. See 7.13 TOUR-PAK LIGHTS, Tour-Pak Lights Harness.
Cable Extension: FLHX/S, FLTRX/S
1. See Figure 7-105. Route antenna cable back along upper left frame, passing back under frame cross member and through opening in left caddy. Continue along saddlebag support to antenna.
2. See Figure 7-103. Pass connector through grommet and connect to bottom of antenna.
3. Capture cable in three upper clips (1).
4. See Figure 7-105. Pull cable snug. Capture antenna cable and rear lighting harness with new cable straps (3).
5. Mate to connector (1)
6. Install left saddlebag.
Leave a Reply