2015 Touring – WIRE TROUGH – REMOVAL

1. Remove main fuse. See 7.3 SYSTEM FUSES AND RELAYS.

2. Remove fuel tank. See 4.6 FUEL TANK.

3. Remove air cleaner and backplate. See 4.5 AIR CLEANER ASSEMBLY.

4. Remove TMAP sensor connector [80]. Pull back yellow lock, push down firmly on latch and disconnect connector.

5. Remove front [84] and rear [85] fuel injector connectors.

6. Remove TCA connector [211]. Release anchored cable strap securing harness to induction module.

7. Disconnect ACR connectors and release connector housings from induction module support.

8. Disconnect terminals from horn and release harness conduit from J-clamp. Release anchored cable strap securing harness to horn bracket.

9. Disconnect ET sensor connector [90].

10. Draw connectors removed in previous steps to right side of motorcycle.

11. ABS models: Release brake lines from wire trough.

12. See Figure 7-106. Cut two cable straps to release breakout harnesses from right side of wire trough.

13. Remove wire trough cover.

14. See Figure 7-107. Using a paint pen, draw a line on both sides of each cable strap securing wire bundles.

NOTE

There are six cable straps. Three cable straps secure the position of the harnesses inside the wire trough and three secure the breakouts on the right side.

NOTE

See Figure 7-108. When removing cable straps, cut off the tail and not the eyelet. The cable strap can then be reused to gather wires when removing harness from wire trough.

15.Cut cables straps and temporarily use to bundle wires:

a. Cut tails of cable straps inside the wire trough as close to the eyelet as possible.
b. Remove each cable strap from slots in wire trough and remove the tail remnant from the eyelet.
c. Install the cable strap back on the harness near the painted lines to gather the bunch of wires. Verify each wire of the harness is captured.

16. Pull breakout harnesses out through slot in breakout compartment. If ABS equipped, move harnesses outboard of brake lines.

17. FLHR/C: Remove fuel gauge harness from slot in front of wire trough.

18. Pry anchor pins at rear of wire trough from holes in frame backbone.

19. Remove wire trough.