NOTE
The gasoline in the fuel supply line is under high pressure (58 psi (400 kPa). To avoid an uncontrolled discharge or spray of gasoline, always purge the line before disconnecting.
1. Relieve pressure from fuel system. See 4.6 FUEL TANK, Removal.
2. Drain fuel from tank. Use a common pump or siphon and an approved gasoline storage container of sufficient capacity.
3. Remove console. See 4.6 FUEL TANK, Console.
4. See Figure 4-12. Remove cam ring using CAM RING REMOVER/INSTALLER (Part No. HD-48646) and raise top plate.
NOTE
See Figure 4-13. Always hold on to both the Cam Ring Remover/Installer and ratchet to prevent unexpected separation resulting in possible damage to the fuel tank.
5. Remove connector at bottom of top plate using a small screwdriver.
6. See Figure 4-14. Disconnect ground wire spade terminal from slot of top plate.
7. See Figure 4-15. Press tabs on fuel line retainers (3) to remove lines from fittings on fuel filter shell.
8. If top plate replacement is necessary, remove fuel filter shell. See 4.8 FUEL FILTER.
Leave a Reply