1. Remove induction module. See 4.13 INDUCTION MODULE.
2. Remove screw to release fuel supply tube clamp from fuel rail.
3. See Figure 4-37. Rotate fuel supply tube clamp 90 degrees clockwise. Remove from groove in fuel supply tube fitting.
4. Pull fuel supply tube from fuel rail bore and remove two O-rings and two sealing washers. Discard O-rings and sealing washers.
5. Pull fuel injectors with attached fuel rail from induction module. Gently rock assembly back and forth while pulling.
6. Remove fuel injectors from fuel rail.
7. Remove O-rings from fuel injectors. Discard O-rings.
Leave a Reply