1. Apply a very light film of clean engine oil to new O-rings.
Install O-rings on fuel injectors.
2. Push open end of fuel injectors (opposite cone spray) into fuel rail.
3. Rotate fuel injectors until the electrical connectors are on the outboard side. Push cone spray end of fuel injectors into bores of induction module until slot at bottom of fuel rail engages machined tab at top of induction module.
4. Install new O-ring and sealing washer in fuel rail bore.
Install second O-ring and second sealing washer.
5. Push fuel supply tube into fuel rail bore.
6. Rotate fuel supply tube clockwise until tapered end of quick connect fitting is pointing upward. Now rotate tube an additional 90 degrees until fitting is pointing rearward (toward TCA on induction module).
7. Engage slot on fuel supply tube clamp in groove of fuel supply tube fitting. Rotate fuel supply tube clamp 90 degrees counterclockwise until curled lip on fuel supply tube clamp engages flange on fuel rail.
8. Secure fuel rail and fuel supply tube clamp to induction module with screw. Tighten to 66-82 in-lbs (7.5-9.3 Nm).
9. Install induction module. See 4.13 INDUCTION MODULE.
Leave a Reply