1. Install new filter in fuel filter shell.
2. Seat O-ring on counterbore at top of filter.
3. Install fuel filter shell over end cap, so that slot in fuel filter shell engages index pin on end cap.
4. Holding parts together, slide U-clip through holes on locking arm side of fuel filter shell. Push U-clip until ends exit holes on opposite side. Retract U-clip until contact is made with step in locking arm.
5. Route ground wire (from top plate TORX screw) around index pin side of end cap and install spade terminal into slot in fuel filter shell. Gently tug on wire to verify that ter- minal is locked.
NOTE
If terminal does not lock, use a thin blade to bend tang slightly away from terminal body.
6. Install top plate. See 4.7 FUEL TANK TOP PLATE.
Leave a Reply