2015 Touring – EVAPORATIVE EMISSIONS CONTROL SYSTEM – PURGE SOLENOID

Written by

Removal

1. Remove seat. See 2.30 SEAT.

2. Remove top electrical caddy and remove purge solenoid from caddy. Lay caddy aside. See 7.6 ELECTRICAL CADDIES.

3. See Figure 4-49. Remove purge solenoid connector (1).

4. Remove purge tubes (2, 3) from purge solenoid.

5. Remove purge solenoid from motorcycle.

Installation

1. See Figure 4-49. Install purge tube to induction module (3) onto fitting of purge solenoid closest to the connector cavity.

2. Install purge tube from charcoal canister (2) onto purge solenoid.

3. Install purge solenoid connector (1).

4. Secure solenoid to top caddy and install top caddy. See 7.6 ELECTRICAL CADDIES.

5. Check all routing to be sure that tubes are not pinched or kinked, and that there is no contact with hot exhaust or engine parts.

6. Install seat. See 2.30 SEAT.

Comments