1. Remove fuel tank. See 4.6 FUEL TANK.
2. Remove air cleaner and backplate. See 4.5 AIR CLEANER ASSEMBLY.
3. See Figure 4-33. Remove ACR connectors and retainer from mounting bracket (3).
4. Twin-Cooled models: Drain coolant and remove upper coolant lines from cylinder heads. See C.5 COOLING SYSTEM REPAIR.
5. California models only: Pull purge tube from fitting (2) at top of induction module.
6. Remove TMAP sensor connector (5).
7. Remove front fuel injector connector (1) and rear fuel injector connector (6).
8. Remove TCA connector (4). Cut anchored cable strap to release connector conduit from front right side of induction module.
9. Remove right side screws from front and rear cylinder head flange adapters. For best results, use the INTAKE MANIFOLD WRENCH (Part No. HD-47250). See Figure 4-34.
10. Loosen left side screws from flange adapters. Slots in flanges make removal of screws unnecessary.
11. Slide induction module out right side of motorcycle.
12. Remove seals from flange adapters. Discard seals. Remove flange adapters from outlet ports of induction module.
Leave a Reply