1. See Figure 4-20. Insert small O-ring at top of pressure port bore.
2. Install screen at top of pressure regulator bore, so that sleeve on ID faces small O-ring. Install regulator seat to evenly press screen into bore. Remove regulator seat.
3. Install large O-ring at top of screen.
4. Install regulator seat and fuel pressure regulator.
5. Install spring clip, so that indented sides engage top of center rib on fuel pressure regulator, while rounded side engages bottom of tabs on housing.
6. Route ground wire around index pin side of end cap and install spade terminal into slot in fuel filter shell.
7. Install top plate. See 4.7 FUEL TANK TOP PLATE.
Leave a Reply