1. See Figure 7-70. Install stator connector [46] (1). Secure connector with locking latch (3).
2. Install voltage regulator connector [77] (2). Secure connector with locking latch (3).
3. See Figure 7-69. Install voltage regulator with locknuts on studs. Tighten to 70-100 in-lbs (7.9-11.3 Nm).
4. Verify that wires are properly secured.
5. Twin-Cooled models:
a. See Figure 7-68. Install screw (5) securing thermostat.
Tighten to 48-60 in-lbs (5.4-6.8 Nm).
b. Install screws (1) securing coolant down tubes.
Tighten to 90-110 in-lbs (10.2-12.4 Nm).
c. Install new cable strap (3). Install coolant pump cover (4).
6. Install main fuse. See 7.3 SYSTEM FUSES AND RELAYS.
7. Verify charging system operation.
Leave a Reply