Removal
1. Remove twist grip sensor. See 4.11 TWIST GRIP SENSOR (TGS), Removal.
2. See Figure 4-30. Securely attach chaser wire to jumper harness.
3. Gently pull jumper harness out through slot at center of handlebar. Remove chaser wire from jumper harness.
Installation
1. Securely attach chaser wire to jumper harness. If equipped, secure heated handgrip connector to harness with electrical tape.
2. Carefully draw connector and jumper harness through handlebar while feeding harness into handlebar.
3. Remove chaser wire from jumper harness.
4. Install twist grip sensor. See 4.11 TWIST GRIP SENSOR (TGS), Installation.
5. See Figure 4-31. Secure TGS jumper harness to handlebar with new cable straps.
Leave a Reply