NOTE
Dirt caked on cooling fins and other areas can fall into crankcase bore. It can also stick to subassemblies as parts are removed. Abrasive particles can damage machined surfaces or plug oil passageways. Clean parts before disassembly to prevent component damage.
1. Use low pressure air to thoroughly clean exterior surfaces of engine prior to disassembly.
2. See Figure 3-14. Following the sequence shown, alternately loosen the six rocker cover bolts. Remove the rocker
cover bolts and their captive washers.
3. Remove the rocker cover and gasket. Discard gasket.
Leave a Reply