Removal
1. See Figure 6-2. Mark position of levers in relation to shaft.
2. Remove pinch screws securing heel and toe shift levers.
3. Remove levers from shaft.
4. Remove rubber spacer.
Repair
1. Remove screw securing rubber peg to lever. Separate screw from peg.
2. Assemble peg to lever with screw. Tighten to 96-144 in-lbs (10.9-16.3 Nm).
Installation
1. Install rubber spacer.
NOTE
Shift lever peg height is a customer preference. During installation, check operation of both shift levers. To achieve proper gear engagement and to avoid damage to transmission, the pegs must not contact the footboard when shifting.
2. Install heel and toe levers. Align to marks made during removal.
3. Install pinch screws. Tighten to 18-22 ft-lbs (24.4-29.8 Nm).
4. Verify shift lever operation.
Leave a Reply