2015 Touring – OIL PAN – INSTALLATION

1. See Figure 3-140. Clean and examine transmission and oil pan flanges.

2. If removed, install tapered plug (4) using LOCTITE 565 THREAD SEALANT. Tighten to 18-22 ft-lbs (24.4-29.8
Nm).

3. Apply a thin coat of HYLOMAR GASKET AND THREAD SEALANT® gasket sealer to oil pan flange.

4. Place new gasket (1) on oil pan flange. Allow sealer to dry until tacky.

NOTE

If oil pan fasteners are to be reused, apply 1-2 drops of LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (blue). New fasteners have a lock patch applied.

5. Position oil pan with gasket on bottom of transmission and loosely install fasteners (6).

6. Verify the gasket is properly positioned and tighten oil pan fasteners (6) to 132-156 in-lbs (14.9-17.6 Nm) following sequence shown in Figure 3-141.

7. Clean engine and transmission drain plugs. Replace Orings as required.

8. Install transmission drain plug and O-ring (5). Tighten to 14-21 ft-lbs (19.0-28.5 Nm).

9. Install engine oil drain plug and O-ring (3). Tighten to 14-21 ft-lbs (19.0-28.5 Nm).

10. Install exhaust crossover pipe hanger bracket and tighten fasteners to 100-120 in-lbs (11.3-13.6 Nm).

11. Install exhaust crossover pipe and left muffler. See 4.18 EXHAUST SYSTEM.

12. Install rear wheel. See 2.5 REAR WHEEL.

13. Add fluids.
a. Add transmission fluid and check level. See 1.11 TRANSMISSION LUBRICANT.
b. Install engine oil filter. Add engine oil and check level. See 1.6 ENGINE OIL AND FILTER.