2015 Touring – OIL COOLER – INSTALLATION

Written by

See Figure 3-11. If replacing the hoses, place new hose clamps (2) on the oil cooler end of the hoses.
Push the hoses onto the oil cooler fittings.
Align the hoses and tighten the hose clamps using HOSE CLAMP PLIERS (Part No. HD-97087-65B).
Secure cooler to frame with screws (1). Tighten to 20-22 ft-lbs (27.1-29.8 Nm).
Place clamps (5) on hoses. Install the hoses into the fittings of the oil cooler adapter. Secure clamps on hoses.
Check the condition of grommets (11) and replace as necessary. Install cover (4), upper latches first, then push
down and back to engage lower pins into grommets.
Start engine and check for oil leaks.
When at operating temperature, perform an oil level HOT CHECK.

Comments