Removal
1. Remove outer fairing. See 2.37 OUTER FAIRING AND WINDSHIELD: FORK MOUNTED FAIRING MODELS or 2.42 OUTER FAIRING AND WINDSHIELD: FRAME MOUNTED FAIRING MODELS.
2. Remove fairing vent. See 2.39 INNER FAIRING: FORK MOUNTED FAIRING MODELS, Fairing Vent or 2.43 INNER FAIRING: FRAME MOUNTED FAIRING MODELS, Removal.
3. Fork mounted fairing: Remove upper fairing support.
See 2.39 INNER FAIRING: FORK MOUNTED FAIRING MODELS, Upper Support Bracket.
4. Disconnect electrical connector.
5. See Figure 7-83. Remove screws (1). Remove back clamp (3), gauge (4) and bezel (5).
Installation
NOTE
See Figure 7-83. Fuel and battery icons (2) are cast into the back clamp and inner fairing near each gauge opening to identify correct location. The voltmeter is always mounted on the right side and uses the tan back clamp. The fuel gauge is always mounted on the left side and uses the black back clamp.
1. Assemble gauge (4), back clamp (3) and bezel (5).
2. Install gauge in inner fairing. Secure with screws (1).
Tighten to 8-15 in-lbs (0.9-1.7 Nm).
3. Install electrical connector.
4. Fork mounted fairing: Install upper fairing support. See 2.39 INNER FAIRING: FORK MOUNTED FAIRING MODELS, Upper Support Bracket.
5. Install fairing vent. See 2.39 INNER FAIRING: FORK MOUNTED FAIRING MODELS, Fairing Vent or 2.43 INNER FAIRING: FRAME MOUNTED FAIRING MODELS, Removal.
6. Install outer fairing. See 2.37 OUTER FAIRING AND WINDSHIELD: FORK MOUNTED FAIRING MODELS or 2.42 OUTER FAIRING AND WINDSHIELD: FRAME MOUNTED FAIRING MODELS.
Leave a Reply