Removal
NOTE
Damaged wiring, terminals and/or connectors requires replacement of the wire harness. Do not replace the special teflon coated wiring with ordinary bulk wire. Ordinary insulation materials may deteriorate when in contact with gasoline.
1. Remove fuel pump. See 4.17 FUEL PUMP.
2. Cut cable strap to release wire harness and both fuel pump and transfer tubes from arm of fuel pump bracket.
3. Release wire harness from molded clip at front of fuel pump bracket.
4. Remove connector at top of fuel pump.
Installation
1. Install connector at top of fuel pump.
2. Route wire harness rearward and then forward under arm of fuel pump bracket. Install new cable strap at elbow capturing fuel pump and transfer tubes at top of arm and wire harness at bottom. See Figure 4-40.
3. Route wire harness through molded clip at front of fuel pump bracket. See Figure 4-41.
4. Install fuel pump. See 4.17 FUEL PUMP.
Leave a Reply