Removal
NOTE
Never operate vehicle with the radio or upper support bracket removed. These components provide important structural support to the fairing. Temporarily install a Police glove box assembly if the vehicle must be operated while the radio is removed. Damage to the fairing assembly can result if operated without either of these components installed.
1. Remove main fuse. See 7.3 SYSTEM FUSES AND RELAYS.
2. Remove outer fairing. See 2.37 OUTER FAIRING AND WINDSHIELD: FORK MOUNTED FAIRING MODELS.
3. Remove fairing vent and upper support bracket. See 2.39 INNER FAIRING: FORK MOUNTED FAIRING MODELS, Upper Support Bracket.
4. Remove instrument cluster. See 7.29 GAUGES AND INSTRUMENTS: FAIRING MODELS.
NOTE
Some connectors are not used on all models.
5. See Figure 7-89. Disconnect:
a. Radio harness connector (6).
b. USB connector (5).
c. AM/FM antenna cable connector (4).
d. GPS connector (3).
e. SiriusXM connector (2) (if equipped)
6. See Figure 7-91. Remove four screws (1) to release radio from fairing support brackets.
7. Pull radio up and forward to remove.
NOTE
The XM module is very fragile and is sensitive to static discharge.
8. XM equipped:
a. Remove screws securing XM module in radio frame.
b. Transfer XM module into new radio immediately. If new radio is not available, place XM module in a static proof bag and store in a safe place.
c. Tighten screw securely.
Installation
NOTE
Confirm foam tape is in place on inner fairing near radio opening.
1. Position radio on fairing support brackets and push toward opening in inner fairing.
2. See Figure 7-91. Install four screws (1). Leave fasteners loose.
3. Install instrument cluster. See 7.29 GAUGES AND INSTRUMENTS: FAIRING MODELS.
4. See Figure 7-90. Install upper support bracket (3). Tighten upper bracket screws in the sequence shown in 2.39 INNER FAIRING: FORK MOUNTED FAIRING MODELS, Upper Support Bracket.
5. See Figure 7-91. Tighten screws (1) to 60-84 in-lbs (6.8-9.5 Nm).
NOTE
Some connectors are not used on all models.
6. See Figure 7-89. Mate connectors:
a. Radio harness connector (6).
b. USB connector (5).
c. AM/FM antenna cable connector (4).
d. GPS connector (3).
e. SiriusXM connector (2) (if equipped)
7. Install fairing vent and outer fairing. See 2.39 INNER FAIRING: FORK MOUNTED FAIRING MODELS, Fairing Vent.
8. Install main fuse. See 7.3 SYSTEM FUSES AND RELAYS.
9. If installing a new radio, it must be set up using DIGITAL TECHNICIAN II (Part No. HD-48650):
a. Choose the REFLASH icon.
b. Follow the on-screen prompts. If the vehicle has an amplifier, it must also be configured after configuring the radio.
NOTE
Instructions to check, download and install software are available in PDF format at www.harley-davidson.com/softwaredownloads.
10. Check software version:
a. Visit www.harley-davidson.com/softwaredownloads.
b. Compare the software version number to the online version number.
c. If the online version number is higher than the displayed version number, download and install the latest version.
Leave a Reply