Removal
NOTE
On models not equipped with auxiliary/fog lamps, removal of lamp bracket is similar.
1. Road King Models:
a. See Figure 7-18. Disconnect both lamp connectors (3, 4) located on left steering head.
b. Cut cable straps securing harnesses to lower fork bracket.
c. Pull harnesses down through openings in lower fork bracket.
d. Loosen acorn nuts securing lamp bracket.
2. Fairing Models:
a. Remove acorn nuts securing lamp brackets.
b. Pull lamp bracket away from fork and separate electrical connector.
3. Remove auxiliary/fog lamp bracket.
Installation
1. Fairing Models:
a. Mate electrical connector.
b. Install auxiliary/fog lamp bracket.
c. Install acorn nuts. Tighten to 120-180 in-lbs (13.6-20.3 Nm).
2. Road King Models:
a. Install auxiliary/fog lamp bracket with bushings outside bracket.
b. Tighten acorn nuts to 72-108 in-lbs (8.1-12.2 Nm).
c. See Figure 7-18. Pull harnesses up through openings in lower fork bracket.
d. Connect both lamp connectors (3, 4).
e. Install cable straps securing harnesses to lower fork bracket.
Leave a Reply