2015 Touring – EVAPORATIVE EMISSIONS CONTROL SYSTEM – SOLENOID-TO-INDUCTION MODULE TUBE

Removal

1. Remove seat. See 2.30 SEAT.

2. Remove fuel tank. See 4.6 FUEL TANK.

3. See Figure 4-48. Remove purge tube (3) from purge solenoid.

4. Remove cable clip on purge tube from frame backbone.

5. Disconnect tube from fitting on induction module.

6. Remove purge tube.

Installation

1. Route purge tube rearward under frame crossmember and into area near purge solenoid, then along bottom of frame backbone toward induction module. Connect to fitting on induction module.

2. See Figure 4-48. Route purge tube under frame crossmember and install on upper fitting (3) of purge solenoid.

3. Secure purge tube to bottom of frame backbone with new retainer.

4. Install fuel tank. See 4.6 FUEL TANK.

5. Install seat. See 2.30 SEAT.