Never bend belt forward into a loop smaller than the drive sprocket diameter. Never bend belt into a reverse loop. Over bending can damage belt resulting in premature failure, which could cause loss of control and death or serious injury. (00339a)
1. Install belt over transmission sprocket.
2. Install the primary chaincase housing. See 5.5 PRIMARY CHAINCASE HOUSING, Installation.
NOTE
Always install a new gasket between primary chaincase cover and chaincase. Failure to replace this gasket may cause primary chaincase leaks.
3. Install primary chain assembly. See 5.4 DRIVE COMPONENTS.
4. Install primary chaincase cover. Fill primary chaincase with lubricant. See 5.3 PRIMARY CHAINCASE COVER.
5. Install rear fork and rear wheel. See 2.22 REAR FORK.
6. Adjust belt tension. See 1.14 DRIVE BELT AND SPROCKETS.
Leave a Reply